| Hardware | Module | Parameters |
| Seagate ST0X | seagate.o | controller_type=1 base_address=base_addr irq=irq |
| F. Domain TMC-8xx | seagate.o | controller_type=2 base_address=base_addr irq=irq |
| F. Domain TMC-3260 | fdomain.o | setup_called=1 port_base=base_addr interrupt_level=irq |
| AHA-2920 | fdomain.o | setup_called=1 port_base=base_addr interrupt_level=irq |
| Trantor T128 | t128.o | t128=base_addr,irq |
| NCR-5380 Based | g_NCR5380.o | ncr5380=base_addr,irq,dma_channel |
| AHA 152x | aha152x.o | aha152x=base_addr,irq,scsi_id,reconnect,parity |
| AHA 1542 | aha1542.o | bases=base_addr |
| Buslogic | BusLogic.o | buslogic=base_addr |
| PAS-16 SCSI | pas16.o | pas16=base_addr,irq |
| Zip Parallel Port | ppa.o | ppa_base=base_addr |
| Always In2000 | in2000.o | setup_string="ioport:base_addr noreset nosync:x period:ns disconnect:x debug:x proc:x" |
Some examples would be:
| Configuration | Example |
| Adaptec AHA1522 at port 330, IRQ 11, SCSI ID 7 | aha152x=0x330,11,7 |
| Adaptec AHA1542 at port 330 | bases=0x330 |
| Future Domain TMC-800 at CA000, IRQ 10 | controller_type=2 base_address=0xca000 irq=10 |
When a parameter has commas, make sure you do not put a space after a comma.